9/25/2023 0 Comments Pergolas with roofsThe motor automatically stops at its fully extended position, which positions the louvers at 150 degrees, however, it can be stopped using the remote control at any position in-between, enabling the louvers to be perfectly positioned based on the angle of the sun to provide sun or shade under the pergola.įurthermore, a rain sensor can be connected to the motor configuration, wired into the circuit board built within the pergola framework which senses rainfall (like an automatic car windscreen wiper) and sends a close command to the motor, with the motor shaft retracting subsequently rotating the louvers fully closed, where they will form an entirely watertight roof covering. When a command is sent from the remote control to open the motor, the motor drive shaft extends at an angle, pushing the louver drive arm it is connected to, subsequently causing the roof louvers to rotate on their pins. The pergola motor is connected to a receiver built within the structure framework that enables it to be activated by radio transmitter – a handheld remote control. This drive arm is subsequently connected to a linear actuator motor, the type used to open large skylights and rooflights, with the motor positioned either on the inside of the cross beam ( Deluxe model) or to the top of the cross beam ( Classic model). Additionally, a second pin to the rear of each louver connects to an aluminium drive arm. The louvers are connected via hi-tensile stainless steel pins in each end, into punched slots within the front and rear cross beam of the pergola. Our pergolas with opening roofs, more often referred to as louvered roofs or Outdoor Living Pods, feature a series of extruded aluminium louvers that form the roof, each interlocking (overlapping) with each other to provide a watertight covering.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |